Show Port; Show Port Protocol - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

show port

This command displays port information.
Format
Mode
Slot/Port
Type
Admin Mode
Physical Mode
Physical Status
Link Status
Link Trap
LACP Mode

show port protocol

This command displays the Protocol-Based VLAN information for either the entire system, or for
the indicated Group.
Format
Mode
Group Name
8-48
show port {<slot/port> | all}
Privileged EXEC
Valid slot and port number separated by forward slashes.
If not blank, this field indicates that this port is a special type of port.
The possible values are:
Mon - this port is a monitoring port. Look at the Port Monitoring
screens to find out more information.
Lag - this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Selects the Port control administration state. The port must be enabled
in order for it to be allowed into the network. - May be enabled or dis-
abled. The factory default is enabled.
Selects the desired port speed and duplex mode. If auto-negotiation sup-
port is selected, then the duplex mode and speed will be set from the
auto-negotiation process. Note that the port's maximum capability (full
duplex -100M) will be advertised. Otherwise, this object will determine
the port's duplex mode and transmission rate. The factory default is
Auto.
Indicates the port speed and duplex mode.
Indicates whether the Link is up or down.
This object determines whether or not to send a trap when link status
changes. The factory default is enabled.
Displays whether LACP is enabled or disabled on this port.
show port protocol <groupid | all>
Privileged EXEC
This field displays the group name of an entry in the Protocol-based VLAN
table.
202-10102-01, May 2005
Switching Commands