Snmptrap - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
10.1.13.1 no snmp-server traps stpmode
This command disables the sending of new root traps and topology change notification
traps.
Format
Mode

10.1.14 snmptrap

This command adds an SNMP trap receiver. The maximum length of
sensitive alphanumeric characters. The
version parameter options are snmpv1 or snmpv2.
The parameter does not need to be unique, however; the
<name>
pair must be unique. Multiple entries can exist with the same
associated with a different
The reverse scenario is also acceptable. The
sending the trap to the receiver, but the
Community Table. For more information, see
on page 2.
Default
Format
Mode
10.1.14.1 no snmptrap
This command deletes trap receivers for a community.
Format
Mode
SNMP Commands
no snmp-server traps stpmode
Global Config
<snmpversion>
.
<ipaddr>
<name>
is not directly associated with the SNMP
<name>
Section 10.1.2 "snmp-server community"
snmpv2
snmptrap <name> <ipaddr> [snmpversion <snmpver-
sion>]
Global Config
no snmptrap <name> <ipaddr>
Global Config
v1.0, October 2008
<name>
is the version of SNMP. The
and
<name>
as long as they are
<name>
is the community name used when
is 16 case-
<ipaddr>
10-7