Snmptrap Snmpversion - NETGEAR GSM7228PS Cli Manual

Note: The <name> parameter does not need to be unique, however; the <name> and
<ipaddr> pair must be unique. Multiple entries can exist with the same <name>,
as long as they are associated with a different <ipaddr>. The reverse scenario is
also acceptable. The <name> is the community name used when sending the trap
to the receiver, but the <name> is not directly associated with the SNMP
Community Table, See "snmp-server community" on page39."
Default snmpv2
Format
snmptrap <name> <ipaddr> [snmpversion <snmpversion>]
Mode Global Config
no snmptrap
This command deletes trap receivers for a community.
Format
no snmptrap <name> <ipaddr>
Mode Global Config

snmptrap snmpversion

This command modifies the SNMP version of a trap. The maximum length of <name> is 16 case-
sensitive alphanumeric characters. The <snmpversion> parameter options are snmpv1 or
snmpv2.
Note: This command does not support a "no" form.
Default snmpv2
Format
snmptrap snmpversion <name> <ipaddr> <snmpversion>
Mode Global Config
Management Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
10-47