M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.8 PLC Message Development
5.8.4 Writing Message to CNC Controller on Standard Screen
The following operation procedure shows how to write massages to the CNC controller from the standard screen.
For details on the operation on the input/output screen, refer to the instruction manual of the CNC controller.
File names and directory names of PLC messages differ depending on by whom they are used (MTB or users).
PLC messages for users are displayed when "E/U mode" is enabled.
For details on the "E/U mode", refer to "9.1 Enhanced PLC Security Mode".
5.8.4.1 Operation Procedure
(1) Press [I/O] menu on the maintenance screen.
177
IB-1501614-B