Rename Data Popup Screen; Outline; Screen Display Items; Enabled/Disabled State Of Menu Keys - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus

6.13.7 Rename Data Popup Screen

6.13.7.1 Outline

This enables the name of PLC data stored in the current project to be changed.

6.13.7.2 Screen Display Items

The following table describes the screen display items for the rename data popup screen.
Item name
Data type
Old data name
New data name
Title
(*1) Selecting data of different types (program, comments, and parameters) from the list on the file operation screen and dis-
playing this data on the rename data screen causes the data type and data name of the selected data to be selected and
displayed. If parameter data is selected, however, characters cannot be entered into blank fields for old data names and
new data names.
(*2) Refer to "6.6.1 PLC Data Used by the PLC On-board" for information on restrictions to PLC data names and titles.

6.13.7.3 Enabled/Disabled State of Menu Keys

The following information describes the conditions upon which menu keys displayed on the rename data popup screen are
enabled/disabled.
The menu keys which are not described in the following table are always enabled.
Menu name
Old data name
New data name
This displays programs, comments, and parameters.
Programs are the default selection.(*1)
This is left blank.(*1)
These are restricted to a maximum of 8 single-byte alphanumeric numeric char-
acters.(*2)
This is left blank.
These are restricted to a maximum of 8 single-byte alphanumeric numeric char-
acters.(*2)
This is left blank.
These are restricted to a maximum of 8 single-byte alphanumeric numeric char-
acters.(*2)
Condition upon which it is enabled/disabled
Enabled when data type is other than parameter.
Enabled when data type is other than parameter.
Display state
365 IB-1501614-B