M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.9 Creating Device Comment
5.9.4 Writing Device Comments to CNC Controller
This section describes how to write device comments from GX Works2 to the CNC controller.
5.9.4.1 Operation Procedure
(1) Start the operation screen by the following operation on GX Works2.
[Online] -> [Write to PLC]
(2) Select [Program Memory/Device Memory] from [Target Memory Setting] on the following screen, select device comment
files to write, and click [Execute].
Note
[Program Memory/Device Memory] is the only valid option for [Target Memory Setting].
IB-1501614-B
194