M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.6 Developing Simple Project
5.6.8.8 Option Setting Screen for Ladder Program Writing during RUN (Online Change)
When the ladder program writing during RUN is to be executed to a CNC, display the setting screen by selecting [Tool] -
[Options] - [Online Change] to set the following optional items.
(1) Execute fall instruction
Do not check this item. Regardless of the setting, the first fall instruction is not executed in a CNC after the setting is
changed.
(2) Transfer program cache memory to program memory
Check this item.
When this item is not checked, the following dialog is displayed while executing ladder program writing during RUN.
CNC performs RUN write only regardless of whether you choose "Yes" or "No".
(3) Execute online change based on relative step No.
Do not check this item. "Relative step No. by pointer" is not supported.
When a pointer (P) is included in the ladder block to be written during RUN with this item checked, an error will occur.
(4) Execute online change by Compile
Refer to "Setting Options for Ladder Program Writing during RUN before Executing Conversion" in "5.6.8.7 Operation
method on the GX Works2", and check this item as necessary.
(5) Under booting, reflect changes to boot source during online program change
Do not check this item. Booting operation is not supported by CNC.
IB-1501614-B
150
(1)
(2)
(3)
(4)
(5)