Mitsubishi Electric M800VW Series Manual page 563
Plc development
Hide thumbs
Also See for M800VW Series:
- Connection and set up manual (696 pages) ,
- Programming manual (968 pages)
Table of Contents
Advertisement
M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus
Screen display items
The following table describes the screen display items on the trace execution screen.
Item name
Connected NC name
Current project No.
Current project label
Alarm message
Left arrow key
Software keyboard
Trace status
Monitor
Repeat frequency
Enabled/disabled state of menu keys
The following table describes the conditions upon which menu keys displayed on the trace execution screen are enabled/
disabled.
The menu keys which are not described in the following table are always enabled.
Menu name
PLC RUN/STOP
Status during screen displays
The following table describes the status when the trace execution screen is displayed.
Item name
Trace status (Total)
Trace status (After trigger)
Trace status (Trace)
Trace status (Monitor)
Trace status (Repeat frequency) This displays "0" .
Operation of key presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Start Trace
Stop Trace
Execute trigger
Start monitor/Suspend monitor
Trace result
PLC RUN/STOP
Close
IB-1501614-B
This displays the name of the connected NC.
This displays the current project number.
This displays the project label.
Alarm messages are displayed when alarms occur.
This is displayed when enabled.
This is displayed only when parameters are enabled.
This displays the trace status with the scroll bar and percentage (ratio).
This displays the trace monitor information.
This displays the number of repeated times during the trace execution.
Condition upon which it is enabled/disabled
Disabled when the function is restricted.
This displays "0%" .
This displays "0%" .
This displays "EXECUTION FAILED".
This displays "MONITORING".
Refer to "Closing the trace execution screen".
Refer to "Starting or stopping the trace".
Refer to "Starting or stopping the trace".
Refer to "Executing the trigger".
Refer to "Starting or suspending the trace status monitor".
The trace result display screen is displayed.
This displays the PLC RUN/STOP screen.
Refer to "6.13.10 PLC RUN/STOP Popup Screen".
Refer to "Closing the trace execution screen".
Display state
Operation
Operation
538
Advertisement
Table of Contents
