Storing Method Of The Updating Version Data - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus

6.13.13.5 Storing Method of the Updating Version Data

The updating version data is stored in the directory named "ladXX" that is located directly under the external device. ("XX" is a
two-digit number representing the project No., from "01" to "06".)
The "ladXX" directory is located directly under the external device and is case-insensitive.
For a single project, store the data in "lad01" which is project No.1.
There are two storage methods, and the method to be stored in project format will have a priority.
A project created with PLC Works2 cannot be used on PLC update screen. Use a project created with GX Developer or PLC
on-board.
Method for directly storing the PLC data file in "ladXX" directory
This is the method for directly storing the individually prepared PLC data in "ladXX" directory.
Storage example (Project No.1)
External device
lad01
1
LAD1.wgp
LAD2.wgp
LAD3.wgp
Comm1.wcd
Comm2.wcd
Comm3.wcd
Param.wpa
In this method, the temporary work directory "WorkTemp" is created when updating the PLC version directly under the
"ladXX" directory and is deleted after the update.
The external device requires the following free capacity because the fixed file and the PLC data selected on the PLC version
up screen are stored in "WorkTemp".
Free capacity to be required = Fixed file size (128 kilobytes) + PLC data file size
Method for storing project-format data in "ladXX" directory
This is the method for directly storing the project format directory for GX Developer to the "ladXX" directory. The project format
directory name is fixed to "plcproj" and is case-insensitive.
Storage example (Project No.1)
External device
lad01
1
plcproj
Project.inf
Gppw.gps
Gppw.gpj
ProjectDB.md
b
Resource
Param.wpa
Pou
u
Body
LAD1.wgp
LAD2.wgp
LAD3.wgp
Body
Comm1.wcd
Comm2.wcd
Comm3.wcd
391 IB-1501614-B