Change Nc Connection Screen; Outline - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.16 Environment Setting Menus

6.16.5 Change NC Connection Screen

6.16.5.1 Outline

When the NC display unit and the NC control unit are connected in a ratio of one display unit to multiple NC control units, the
NC unit connected with the PLC On-board can be selected. (At the initial start-up of the PLC On-board, the system connects
to the same NC unit as the HMI screen side.)
Note
(1) When switching to another connected NC (control unit), the following information will be discarded.
 All PLC data in the on-board editing area will be discarded. (Program data with unconverted ladders will also be dis-
carded.)
NC display unit
(on-board)
M01 M02
NC control unit NC control unit
IB-1501614-B
M0n
NC control unit
504