Reading Sequence Programs From Cnc Controller; Operation Procedure - Mitsubishi Electric M800VW Series Manual

Plc development

Hide thumbs Also See for M800VW Series:

Table of Contents

M800V/M80V Series PLC Development Manual

5 Peripheral Development Environment (GX Works2)

5.7 Developing Structured Project

5.7.5 Reading Sequence Programs from CNC Controller

This section describes how to read GX Works2 sequence programs from the CNC controller.

(1) Start the operation screen by the following operation on GX Works2.

[Online] -> [Read from PLC]

(2) Select [Program Memory/Device Memory] in [Target Memory Setting] for [Symbolic Information] on the following screen.

Select "GX Works2 (Structured project)", and click [Execute].

 [Program Memory/Device Memory] is the only valid option for [Target Memory Setting].

 Click [Refresh] before reading symbolic information.

 For details on read parameters before reading symbolic information, refer to "5.5.8.6 Writing and Reading Parameters

to CNC Controller".

 When symbolic information is read, labels and FB are also read as well as sequence programs.

IB-1501614-B