Device Batch Monitor Screen; Outline; Screen Display Items - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus

6.17.2 Device Batch Monitor Screen

6.17.2.1 Outline

This enables multiple consecutive devices to be monitored simultaneously in list format after designating one type of device.
The program cannot be searched by label name.

6.17.2.2 Screen Display Items

The following table describes the screen display items on the device batch monitor screen.
Item name
Connected NC name
Current project No.
Current project label
Monitor/Edit display
PLC status and overwrite/insert display
Alarm message
Left arrow key
Software keyboard
Device
Format
Display
Format
List
IB-1501614-B
Display state
This displays the name of the connected NC.
This displays the current project number.
This displays the project label.
Starting the monitor displays "MONITOR". Stopping the monitor cancels
the display.
This displays the PLC status (RUN/STOP) for the monitored project.
Alarm messages are displayed when alarms occur.
This is displayed when enabled.
This is displayed only when parameters are enabled.
This displays the device to be monitored.
This displays the [BIT & WORD], [BIT MULTIPOINT], and [WORD MUL-
TIPOINT] options.
This displays the [16 BIT INT.], [32 BIT INT.], [SINGLE PRCN], [DOU-
BLE PRCN] and [STRING] options.
This displays the [DEC] and [HEX] options.
This displays the monitoring results.
508