M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus
6.13.5.5 Operation of Key Presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Data name
Title
Add
Close
6.13.5.6 Adding PLC Data
Normal operation
(1) Press the [DATA NAME] menu key and enter the desired PLC data name into the data name input field.
(2) Press the [TITLE] menu key and enter a title that identifies the PLC data you are adding into the title input field. (Entering
titles is optional.)
(3) Press the [ADD] menu key. Pressing this key closes the add new data popup screen and adds the PLC data with the
entered name and title. The name of the added PLC data displays in the list on the file operation screen.
The added PLC data is operated as a project without labels.
If PLC data with the same name already exists, the confirm overwrite popup screen is displayed.
If PLC data is added while the PLC is running, a message confirming whether or not to pause the PLC is displayed. Select
[YES] to stop the PLC and continue adding the PLC data. If [NO] is selected, the PLC does not stop which results in an error
and the display of an error message. (Refer to "Abnormal operation")
If the PLC stops, a message displays to confirm whether or not to restart the PLC immediately after data has been added.
Select [YES] to continue running the PLC. Select [NO] to keep the PLC stopped.
IB-1501614-B
Refer to "6.13.5.7 Closing the Add New Data Popup Screen".
This selects the data name input field.
This selects the title input field.
Refer to "6.13.5.6 Adding PLC Data".
Refer to "6.13.5.7 Closing the Add New Data Popup Screen".
360
Operation