Mitsubishi Electric M800VW Series Manual page 556

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus
Screen display items
The following table describes the screen display items on the trigger point setup screen.
Item name
Connected NC name
Current project No.
Current project label
Alarm message
Left arrow key
Software keyboard
Specified devices
Enabled/disabled state of menu keys
The following table describes the conditions upon which menu keys displayed on the trigger point setup screen are enabled/
disabled.
The menu keys which are not described in the following table are always enabled.
Menu name
Bit device setup
Word device setup
Device setup condi.
Select data
Status during screen displays
The following table describes the status when the trigger point setup screen is displayed.
Item name
Trigger point setup
Specified devices
This displays the name of the connected NC.
This displays the current project number.
This displays the project label.
Alarm messages are displayed when alarms occur.
This is displayed when enabled.
This is displayed only when parameters are enabled.
This displays the specified device and device setup conditions when the trigger point is "SPEC-
IFIED DEVICES".
Condition upon which it is enabled/disabled
Enabled when the trigger point is "SPECIFIED DEVICES".
Enabled when the trigger point is "SPECIFIED DEVICES".
Enabled when the trigger point is "SPECIFIED DEVICES".
Enabled when the trigger point is "SPECIFIED DEVICES", and the focus is at the "SPECIFIED
DEVICES".
This selects "OPERATION".
This is left blank with entry disabled state.
Display state
Operation
531 IB-1501614-B