Mitsubishi Electric M800VW Series Manual page 297

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.2 Screen Configuration
[Edit menus]
This menu contains functions used to edit circuits.
 First page
 Second page
MONITOR
Ladder Symbol 1
LADDER SYMBOL2
COPY/INSERT
FIND
FIND STEP NO.
CONVERT LADDER
UNDO
PROGRAM CHANGE
CROSS REF. LIST
LIST OF USED DEVCES
CHECK PROGRAM
COMMENT ON/OFF
CANCEL EDIT LADDER
ZOOM DISPLAY
OVR.WRITE/INSERT
[Menus of ladder symbol 1 and 2]
This menu contains ladder symbols used to edit circuits.
 [LADDER SYMBOL1] menu
 [LADDER SYMBOL2] menu
Ladder symbols other than the
following
- (Horizontal bar)
| (Vertical bar)
| DELETE (Vertical bar)
CONVERT LADDER
UNDO
IB-1501614-B
This switches to the monitor mode.
This switches to the [LADDER SYMBOL1] menu.
This switches to the [LADDER SYMBOL2] menu.
This switches to the [COPY/INSERT] menu.
This displays the find popup screen.
This displays the find step No. popup screen.
This converts edited circuits.
This returns the pre-converted ladder to the last previous state while editing.
This changes to the selected program.
This displays the contact coil usage popup screen.
This displays the list of used devices popup screen.
This opens the check program popup screen.
This turns the device comment display ON and OFF.
This discards the unconverted ladder.
This changes the display magnification of the ladder screen.
This switches the edit mode between overwrite and insert mode.
This opens the enter symbol popup screen.
Writes the horizontal bar to the cursor position.
Writes the vertical bar to the cursor position.
This deletes the vertical bar at the cursor position.
This converts edited circuits.
This returns the pre-converted ladder to the last previous state while editing.
272