Enabled/Disabled State Of Menu Keys; Status During Screen Displays; Operation Of Key Presses - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus

6.17.3.3 Enabled/Disabled State of Menu Keys

The menu keys displayed on the entry device monitor screen are always enabled.

6.17.3.4 Status during Screen Displays

The following table describes the status when displaying the entry device monitor screen.
Item name
List

6.17.3.5 Operation of Key Presses

The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
LIST
INSERT LINE
DELETE LINE
CHANGE DISPLAY FORMAT
DEC/HEX
DELETE ALL DEVICES
START/STOP MONITOR
DEVICE TEST
PLC RUN/STOP
Close
IB-1501614-B
This is left blank.
Refer to "6.17.3.9 Closing the Entry Device Monitor Screen".
The focus is applied to the list.
This inserts a blank line at the cursor position in the list.
This deletes one blank line at the cursor position in the list.
This switches the display of the current value in the list between a 16-bit display,
a 32-bit display, a single precision display, a double precision display, and a
string display.
This switches the display of the current value in the list between a decimal dis-
play and a hexadecimal display.
This deletes all the devices registered in the list.
Refer to "6.17.3.7 Deleting Devices".
Refer to "6.17.3.8 Starting and Stopping the Monitor for the Selected Device".
This displays the device test popup screen.
Refer to "6.15.5 Device Test Popup Screen".
This displays the PLC RUN/STOP screen.
Refer to "6.13.10 PLC RUN/STOP Popup Screen".
Refer to "6.17.3.9 Closing the Entry Device Monitor Screen".
512
Operation
Operation