Monitoring Sequence Programs; Operation Procedure - Mitsubishi Electric M800VW Series Manual

Plc development

Hide thumbs Also See for M800VW Series:

Table of Contents

M800V/M80V Series PLC Development Manual

5 Peripheral Development Environment (GX Works2)

5.6 Developing Simple Project

5.6.9 Monitoring Sequence Programs

The monitoring of sequence programs has no operation specific to Mitsubishi Electric CNC. For details on operating

procedure, refer to "GX Works2 Operating Manual (Common)". For details on functions that can be used, refer to "5.3.6

Function Support Status (Online)". This section provides the overview of the operating procedure and cautions.

Start monitoring by the following operation on GX Works2.

(1) Display sequence programs to be monitored, and move to the ladder to be monitored.

(2) Start monitoring by either of the following operations.

Select [Online] - [Monitor] - [Monitor Mode] or press "F3" key.

(3) Stop monitoring by either of the following operations.

Select [Online] - [Monitor] - [Monitor Mode] or press "Alt" and "F3" keys simultaneously.

(1) When the sequence programs running on the CNC controller and the sequence programs displayed on GX Works2 are

different, errors are not generated even if monitoring is executed, and monitoring appears to continue normally.

Before executing monitoring, ensure that sequence programs in the CNC controller and GX Works2 are the same.

IB-1501614-B