Mitsubishi Electric M800VW Series Manual page 575

Plc development

Hide thumbs Also See for M800VW Series:

Table of Contents

M800V/M80V Series PLC Development Manual

6 Explanation of Built-in Editing Function (PLC On-board)

6.17 Device Menus

Abnormal operation

This information describes the details of error messages displayed on the trace file read screen and the corrective action

Error message

The NC cannot execute during trace. Ex-

ecute again after trace is completed.

The trace file of the trace condition not

supporting it with MITSUBISHI CNC in the

trace file made with GX Developer cannot

Closing the trace file read screen

Use any of the following methods to close the trace file read screen.

Methods to close the screen

Execute the trace file read.

Press the [CLOSE] menu key.

Press the left arrow key.

Press the [ESC] key on the software keyboard.

IB-1501614-B

Error details

This is displayed when executing an oper-

ation during trace.

This is displayed when reading a trace file

of the trace condition that was created by

GX Developer and is not supported with

Mitsubishi Electric CNC.

Execute the operation during trace stop.

Read a trace file of the trace condition

which is supported with Mitsubishi Electric