M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.10 Creating Label
5.10.5 Writing Label Setting to CNC Controller
This section describes how to write label setting from GX Works2 to the CNC controller (particularly restrictions and operation
specific to this CNC).
5.10.5.1 Operation Procedure
(1) Start the operation screen by the following operation on GX Works2.
[Online] -> [Write to PLC]
(2) After selecting [Program Memory/Device Memory] as the symbolic information as [Target Memory Setting] on the follow-
ing screen, [Program Memory/Device Memory] as [Target Memory Setting] of PLC data, select the symbolic information
file, and click [Execute].
Note
[Program Memory/Device Memory] is the only valid option for [Target Memory Setting].
When symbolic information is written, sequence programs and FB are written as well as labels.
IB-1501614-B
202