Table of Contents
Advertisement
Making Measurements on the ENA
Starting the Lightwave Component Analyzer on the ENA
42
1 Turn on the network analyzer and the optical test set.
2 Load the LCA macros.
a Press the "Macro Setup" button on the front panel of
the network analyzer.
b Select [Load & Run].
c Select LCASYSTEM.
3 Allow the Lightwave Component Analyzer to warm up,
that is until the LEDs for "LD Temp Ready" and "PD
Temp Ready" are lighting.
4 Turn on the laser by turning the key to the upright
position.
The "On" LED lights to indicate the laser is on.
5 If your Lightwave Component Analyzer has more than one
wavelength, select the wavelength at which you want to
measure by pressing the button under the Wavelength
LEDs.
Agilent N4373A Lightwave Component Analyzer, First Edition
Advertisement
Table of Contents
