INVT Goodrive 35 Series Operation Manual page 53

inverters Keypad operation procedure
Goodrive35
cannot be modified. The possible reasons could be:
1) This function code is not modifiable parameter, such as actual detected parameter,
operation records and so on;
2) This function code is not modifiable in running state, but modifiable in stop state.
Example: Set function code P00.01 from 0 to 1.
Fig 5-3 Sketch map of modifying parameters
5.4.2 How to set the password of the inverter
Goodrive35 series inverters provide password protection function to users. Set P7.00 to gain
the password and the password protection becomes valid instantly after quitting from the
function code editing state. Press PRG/ESC again to the function code editing state,
"0.0.0.0.0" will be displayed. Unless using the correct password, the operators cannot enter
it.
Set P7.00 to 0 to cancel password protection function.
The password protection becomes effective instantly after retreating form the function code
editing state. Press PRG/ESC again to the function code editing state, "0.0.0.0.0" will be
displayed. Unless using the correct password, the operators cannot enter it.
Fig 5-4 Sketch map of password setting
52
www.barghmaher.ir