INVT Goodrive 35 Series Operation Manual page 225

inverters
Goodrive35
Set value
Simple PLC stage
16
Simple PLC cycle
17
18
19
20
21
22
MODBUS communication
23
virtual terminal output
POROFIBUS communication
24
virtual terminal output
Ethernet virtual terminal
25
26 Bus voltage established
27~29
30 Positioning finished
31 Spindle returning finished
32 Spindle scaling finished
33 Speed limiting
34 Low bus voltage
35 Underload stopping output
Speed/position switching
36
Relative parameters list:
Function
Output signal if the simple PLC stage is completed.
completion
Output signal if the 1 simple PLC cycle is completed.
completion
Reserved Reserved
Reserved Reserved
Reserved Reserved
Reserved Reserved
Reserved Reserved
Output corresponding signal according to the setting
value of MODBUS. Output ON signal if the setting
value is 1 and output OFF signal if the setting value
is 0.
Output corresponding signal according to the setting
value of PROFIBUS/CANOPEN. Output ON signal if
the setting value is 1 and output OFF signal if the
setting value is 0.
Output the corresponding signal according to the
Ethernet signal. Output ON when setting as1 and
output
output OFF when setting as 0.
Output ON according to the establishment of bus
voltage
Reserved
Output ON when the positioning is finished
Output ON when the returning is finished
Output ON when the scaling is finished
Output ON when the speed is the upper or lower limit
Output ON when the value is below P8.27
If the enabling bit of P08.26 is valid, and it is in the
underload state, ON signal will be output
When the speed is switched to position control,
finished output ON signal
www.barghmaher.ir
Basic operation instruction
Instructions
224