INVT Goodrive 35 Series Operation Manual page 220

inverters
Goodrive35
Function
code
Polarity selection of the
P05.10
input terminals
P05.11 ON-OFF filter time
P05.12 Virtual terminals setting
Name Detailed instruction of parameters
42: Keypad setting of the torque upper
limit
43: Position reference input (only S8
valid)
44: Spindle direction prohibit
45: Spindle returning /Local position
returning
46: Zero position selection 1
47: Zero position selection 2
48: Spindle scaling selection 1
49: Spindle scaling selection 2
50: Spindle scaling selection 3/Pulse
superposition enabling
51: Switching terminal of position control
and speed control
52: Pulse input disabled
53: Position deviation clear
54: Position proportional gain switch
55: Digital position cycle positioning
enabled
56: E-stop
57: Motor overtemperature fault input
58: Rigid tapping enable
59: Switch to SVPWM control
60: Switch to FVC control
61:PID pole switching
62: Undervoltage stopping input
63: Reserved
0x000~0x1FF
0.000~1.000s
0x000~0x1FF(0:Disabled, 1: Enabled)
BIT0:S1 virtual terminal
219
www.barghmaher.ir
Basic operation instruction
Default
value
0x000
0.010s
0