INVT Goodrive 35 Series Operation Manual page 216

inverters
Goodrive35
Set
value
middle frequency)
28 Counter reset
29 Torque control disabling
30 ACC/DEC disabling
31 Counter trigging
32 Length reset
Frequency
33 increasing/decreasing setting
temporal clear
34 DC braking
Switch between motor1 and
35
36 Switch commands to keypad
Switch commands to
37
Switch commands to
38
communication
Function
the middle frequency.
Counter clear
The inverter shifts from torque control mode to speed
control mode.
Ensure the inverter will not be affected by the external
signals (except for the stopping command) and keep
the current output frequency.
Enable the pulse counter.
Length counter clear
When the terminal closes, the frequency set by
UP/DOWN can be cleared. All set frequency will be
restored into the given frequency by the frequency
command channel and the frequency will come back
to the value after the frequency increasing or
decreasing.
The inverter will begin DC braking after the valid
command.
Motor-shifting can be controlled after the terminal is
motor2 valid.
After the function terminal become valid, the running
command channel will be shifted into keypad running
command channel and the running command channel
will come back to the original state if the function
terminal is invalid.
After the function terminal become valid, the running
command channel will be shifted into terminal running
command channel and the running command channel
terminals
will come back to the original state if the function
terminal is invalid.
After the function terminal become valid, the running
command channel will be shifted into communication
running command channel and the running command
www.barghmaher.ir
Basic operation instruction
Instructions
215