INVT Goodrive 35 Series Operation Manual page 144

inverters
Goodrive35
Function
Name
code
P13.10 Reserved 0~65535
Maladjust Adjust the response of anti-maladjustment. Bigger
ment load inertia may increase the value, but the response
P13.11
detection will be slower.
time Setting range: 0.0~10.0s
High
When the motor speed is faster than the rated
frequency
speed, the parameter is valid, if vibration occurs to
P13.12 compensat
the motor, please adjust the parameter.
ion
Setting range: 0.0~100.0%
coefficient
Braking
When P01.00=0 during the starting of the inverter,
current of
P13.13
set P13.14 to a non-zero value to enter the short
short-circui
circuit braking.
t
When the running frequency is lower than P01.09
Braking
during the stopping of the inverter, set 13.15 to a
retention
P13.14 non-zero value to enter into stopping short circuited
time before
braking and then carry out the DC braking at the time
starting
set by P01.12 (refer to the instruction of
The
P01.09~P01.12) .
braking
Setting range of P13.13: 0.0~150.0%(the inverter)
P13.15 retention
Setting range of P13.14: 0.0~50.0s
time when
Setting range of P13.15: 0.0~50.0s
stopping
P14 Group Serial communication
The setting range:1~247
When the master is writing the frame, the
communication address of the slave is set to 0; the
Local address is the communication address. All slaves on
communic the MODBUS fieldbus can receive the frame, but the
P14.00
salve doesn't answer.
ation
address The communication of the drive is unique in the
communication net. This is the fundamental for the
point to point communication between the upper
monitor and the drive.
Detailed instruction of parameters
143
www.barghmaher.ir
Function codes
Default
Modify
value
○
0
○
0.5s
○
0.0%
○
0.0%
○
0.0s
○
0.0s
○
1