INVT Goodrive 35 Series Operation Manual page 218

inverters
Goodrive35
Set
value
Motor overtemperature fault
57
58 Rigid tapping enable
59 Switch to SVPWM control
60 Switch to FVC control
61 PID pole switching
62 Undervoltage stopping input
63
Relative parameters list:
Function
code
P05.00 HDI input selection
S1 terminals function
P05.01
S2 terminals function
P05.02
S3 terminals function
P05.03
S4 terminals function
P05.04
S5 terminals function
P05.05
S6 terminals function
P05.06
S7 terminals function
P05.07
Function
The motor will stop when fault occurs.
input
The mode is enabled if the terminal is valid
If the terminal is valid in stopping mode, it will switch
to V/F control
If the terminal is valid in stopping mode, it will switch
to FVC control
The terminal is used with P09.03 to switch the output
pole
The terminal and the enabling bit is valid, the inverter
will stop at the time sst by P08.05
Reversed
Name
0: High pulse input
1: Digital input
0: No function
selection
1: Forward rotation operation
2: Reverse rotation operation
selection
3: 3-wire control operation
4: Forward jogging
selection
5: Reverse jogging
6: Coast to stop
selection 7: Fault reset
8: Operation pause
9: External fault input
selection
10:Increasing frequency setting(UP)
11:Decreasing frequency
selection
setting(DOWN)
12:Frequency setting clear
selection
www.barghmaher.ir
Instructions
Detailed instruction of parameters
217
Basic operation instruction
Default
value
0
1
4
7
0
0
0
0