Power Eeprom Configuration Error (0X6384 / 0X166); Brake Chopper Failure (0X7111 / 0X141); Brake Chopper Overcurrent (0X7112 / 0X167); Brake Resistor Maximum Power Limit (0X7181 / 0X142) - Danfoss VLT MSD 510 Operating Manual

Operating Guide | VLT® Multiaxis Servo Drive MSD 510 System
Table 82: Configuration parameters limits error (0x6383 / 0x164)
Code
®
PROFINET
code
0x6383 0x164

9.3.48 Power EEprom configuration error (0x6384 / 0x166)

This error is valid for PSM 510, DAM 510, ACM 510, and SDM 511/SDM 512.
Table 83: Power EEprom configuration error (0x6384 / 0x166)
Code Name
0x6384 0x166 Power Eeprom config-
uration error

9.3.49 Brake chopper failure (0x7111 / 0x141)

This error is valid for PSM 510.
Table 84: Brake chopper failure (0x7111 / 0x141)
Code
®
PROFINET
code
0x7111 0x141

9.3.50 Brake chopper overcurrent (0x7112 / 0x167)

This error is valid for PSM 510.
Table 85: Brake chopper overcurrent (0x7112 / 0x167)
Code
®
PROFINET
code
0x7112 0x167

9.3.51 Brake resistor maximum power limit (0x7181 / 0x142)

This error is valid for PSM 510.
Danfoss A/S © 2019.10
Name Severity (warn‐
ing/error/trip
lock)
Configuration pa- Trip lock
rameters limits er-
ror
Severity (warning/
error/trip lock)
Trip lock
Name Severity (warning/
error/trip lock)
Brake chop- Warning, error
per failure
Name Severity (warning/error/
trip lock)
Brake chopper Trip lock
overcurrent
Description
≥1 parameter in the configuration parameter
set is out of limits: the parameter set is not
valid for this device.
Description
The power device Eeprom is corrupt or
incompatible with this control board.
Description
The brake chopper is monitored during oper-
ation.
A brake failure has been detected by the
brake check function.
Description
The brake chopper current ex-
ceeds the limit.
AQ262450196490en-000101 / 175R1170| 183
Diagnostics
LCP name
conf par
lim
LCP name
conf par EE-
PROM
LCP name
brake ch fail
LCP name
brake ch over-
curr