Danfoss VLT MSD 510 Operating Manual page 107

Operating Guide | VLT® Multiaxis Servo Drive MSD 510 System
Illustration 76:
510 Servo Drives
13. Answer the question if the servo drive is used as an NC axis with No. If the servo drive is to be used as an NC axis, see
Configuration as a TwinCAT® NC
Add 1 entry to the EtherCAT
-
DAM 510, and ACM 510. Add the servo drive to the correct DAM 510 line.
Danfoss A/S © 2019.10
TwinCAT System Manager after Appending the PLC Project and Adding a Decentral Access Module and 2 ISD
Axis.
®
master of the TwinCAT System Manager for each physical servo drive, PSM 510,
N O T I C E
Commissioning
6.12.15
AQ262450196490en-000101 / 175R1170| 107