Direct Communication - Danfoss VLT MSD 510 Operating Manual

Operating Guide | VLT® Multiaxis Servo Drive MSD 510 System
6.16.4.3.7.2 Adding IP Addresses and Subnets
Procedure
1. Open SIMOTION SCOUT
2. Select the menu [Project → Accessible notes].
3. If accessible nodes are found in another subnet, the Add IP addresses / subnet masks window is displayed and shows them.
Illustration 103:
4. Click on Yes to accept the addresses.
5. The IP address/subnet mask is now added.
-
If more than one Danfoss servo drive is used in the same PROFINET
name and IP address.
-
The last number of the IP address is the ID that is used in the VLT
When the Accessible nodes tab is closed, the addresses are retained. The newly added addresses are only discarded
-
when SIMOTION SCOUT

6.16.4.4 Direct Communication

6.16.4.4.1 Overview
For Ethernet-based fieldbus communication (direct communication), the VLT
®
on the VLT Servo Toolbox host system. Do not use this network interface simultaneously for any other communication.
Danfoss A/S © 2019.10
®
.
Accessible Nodes
®
is closed.
N O T I C E
®
network, each servo drive must have a different
®
Servo Toolbox software to identify the device.
®
Servo Toolbox must use a dedicated network interface
Commissioning
AQ262450196490en-000101 / 175R1170| 139