Csta Via Ip - Siemens HiPath 3000 Series Service Documentation

Table of Contents

h3h5_in_the_lan.fm

HiPath 3000/5000 in the LAN Network

Applications over IP

CSTA via IP

The Transmission Control Protocol (TCP) is used for CSTA via IP. A permanent connection is

set up. Data packet loss is detected and automatically corrected.

For HiPath 3000, the following number of server applications may be connected per system:

up to one in HiPath 3300/3350, HiPath 3500/3550

up to four in HiPath 3800

Restrictions may apply to applications that use certain services. For example, only one appli-

cation at a time can start the message registration function.

For an external application to address HiPath 3000/5000, it must know the TCP port (7001) of

the TCP/IP server implemented in HiPath 3000/5000 as well as the IP address. Data packets

sent from an application to HiPath 3000/5000 – that is, packets containing the HiPath IP ad-

dress, TCP port 7001, and protocol type TCP – are accepted for further processing.

HiPath 3000 V7 and later systems support CSTA monitoring of connections to ITSPs. This en-

ables call center applications, for example, to be used, even if SIP trunks are used.

Model-specific data

Feature available in

Hardware requirements

Software requirements

LIM/LIMS is released in HiPath 3800 for administration, fault management and accounting. No

other features or protocols are supported via LIMS!

LIM for HiPath 33x0 and HiPath 35x0 can be used for CTI/CSTA applications in conjunction

with TAPI 120 (up to 6 stations). No other features or protocols are supported via LIM!

V5.0 or later

V1.2 or later

A31003-H3590-S100-7-7620, 06/2012

HiPath 3000/5000 V9, Service documentation

Nur für den internen Gebrauch

HG 1500 / LIM

V1.2 or later

Show Quick Links

Table of Contents