Table 74: Predefined Summer-Time Parameters - Edge-Core ECS4660-28F Management Manual

clock summer-time
(predefined)
This command configures the summer time (daylight savings time) status
and settings for the switch using predefined configurations for several
major regions in the world. Use the no form to disable summer time.
S
YNTAX
clock summer-time name predefined [australia | europe | new-
zealand | usa]
no clock summer-time
name - Name of the timezone while summer time is in effect,
usually an acronym. (Range: 1-30 characters)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
In some countries or regions, clocks are adjusted through the summer
◆
months so that afternoons have more daylight and mornings have less.
This is known as Summer Time, or Daylight Savings Time (DST).
Typically, clocks are adjusted forward one hour at the start of spring
and then adjusted backward in autumn.
This command sets the summer-time time relative to the configured
◆
time zone. To specify the time corresponding to your local time when
summer time is in effect, select the predefined summer-time time zone
appropriate for your location, or manually configure summer time if
these predefined configurations do not apply to your location (see
summer-time (date)

Table 74: Predefined Summer-Time Parameters

Region Start Time, Day,
Week, & Month
Australia 00:00:00, Sunday,
Week 5 of October
Europe 00:00:00, Sunday,
Week 5 of March
New Zealand 00:00:00, Sunday,
Week 1 of October
USA 00:00:00, Sunday,
Week 2 of March
E
XAMPLE
Console(config)#clock summer-time MESZ predefined europe
Console(config)#
R C
ELATED OMMANDS
show sntp (947)
– 953 –
| System Management Commands
C 24
HAPTER
Manual Configuration Commands
or clock summer-time (recurring).
End Time, Day,
Week, & Month
23:59:59, Sunday,
Week 5 of March
23:59:59, Sunday,
Week 5 of October
23:59:59, Sunday,
Week 3 of March
23:59:59, Sunday,
Week 1 of November
clock
Rel. Offset
60 min
60 min
60 min
60 min