Edge-Core ECS4660-28F Management Manual page 970

| System Management Commands
C 24
HAPTER
Precision Time Protocol
ptp
log-sync-interval
D S
EFAULT ETTING
0 (1 second)
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
The log base 2 settings equate to the following values:
◆
0 – 1 packet every second
■
1 – 1 packet every 2 seconds
■
2 – 1 packet every 4 seconds
■
3 – 1 packet every 8 seconds
■
4 – 1 packet every 16 seconds
■
5 – 1 packet every 32 seconds
■
This command is only applicable for interfaces which are set to use the
◆
peer-to-peer delay mechanism with the
command.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ptp log-min-pdelay-request-interval 1
Console(config-if)#
This command sets the synchronization message transmit interval. Use the
no form to restore the default setting.
S
YNTAX
ptp log-sync-interval interval-value
no ptp log-sync-interval
interval-value – The minimum interval between (multicast)
synchronization messages. (Range: -1 - 1 in log base 2)
D S
EFAULT ETTING
0 (1 second)
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
The log base 2 settings equate to the following values:
◆
- 1 – 1 packet every 1/2 second
■
0 – 1 packet every second
■
1 – 1 packet every 2 seconds
■
– 970 –
ptp delay-mechanism