Edge-Core ECS4660-28F Management Manual page 941

Hide thumbs Also See for ECS4660-28F:

Table of Contents

This command specifies SMTP servers that will be sent alert messages. Use

logging sendmail

the no form to remove an SMTP server.

Global Configuration

This command sets the severity threshold used to trigger alert messages.

logging sendmail

Use the no form to restore the default setting.

[no] logging sendmail host ip-address

ip-address - IPv4 or IPv6 address of an SMTP server that will be

sent alert messages for event handling.

You can specify up to three SMTP servers for event handing. However,

you must enter a separate command to specify each server.

To send email alerts, the switch first opens a connection, sends all the

email alerts waiting in the queue one by one, and finally closes the

To open a connection, the switch first selects the server that

successfully sent mail during the last connection, or the first server

configured by this command. If it fails to send mail, the switch selects

the next server in the list and tries to send mail again. If it still fails, the

system will repeat the process at a periodic interval. (A trap will be

triggered if the switch cannot successfully open a connection.)

Console(config)#logging sendmail host 192.168.1.19

Console(config)#

logging sendmail level level

no logging sendmail level

level - One of the system message levels

sent include the selected level down to level 0. (Range: 0-7;

| System Management Commands

934). Messages

Chapters

Table of Contents