RADIOMETER ABL800 FLEX Operator's Manual page 94

3. Installation and setup
Patient reports,
Editing patient You can customize the patient identification (Patient ID) information as follows:
ID layout
To edit a patient ID for a selected patient report layout, do the following:
Step
3-28
Continued
• select the items to be included in the Patient ID.
• set Patient ID entries as mandatory.
• define default values for Patient ID.
Action
1. To add a highlighted (by touching it on the screen) item in the
"Available items" box, to the list of selected items, press the "→ "
button.
2. To remove a highlighted (by touching it on the screen) item from the
"Selected items" box, press the "←" button.
3. To make a highlighted item in the list of selected items mandatory,
press the Set as Mandatory button. The item will be indicated by a
on the Patient ID screen and must be entered during a measurement
before a patient result can be viewed.
To remove the mandatory mark, highlight the item in the "Selected
items" box and press the Set as Mandatory button again.
NOTICE: If you are using mandatory input fields, you are not
allowed to change the report layout during measurement, unless the
mandatory fields have been filled out.
4. Press Back to exit the screen.
ABL800 FLEX Operator's Manual
Selected patient
report layout
Continued on next page