RADIOMETER ABL800 FLEX Operator's Manual page 323

ABL800 FLEX Operator's Manual
Analyzer messages,
Messages at
manager level
(continued)
Continued
No. Message
718 AutoCheck
carousel
will need
refilling
soon
719 Insufficient
sample in
pH/BG
module
720 Insufficient
sample at
El/Met
module
721 Insufficient
sample in
Met II
module
722 Sample
error
723 No Cleaning
Solution
detected by
inlet during
Startup
724 No Cal 2
Solution
detected by
inlet during
Startup
Interpretation
AutoCheck ampoule
stock is low.
Air bubbles were
detected in the sample
with possible
implications on
measurement accuracy.
All parameters are
marked with "?".
Air bubbles were
detected in the sample
with possible
implications on
measurement accuracy.
All affected parameters
are marked with "?".
Air bubbles were
detected in the sample
with possible
implications on
measurement accuracy.
All affected parameters
are marked with "?".
Insufficient or
inhomogeneous sample
during measurement.
pH/BG module was not
filled correctly with
Cleaning Solution
during Startup.
pH/BG module was not
filled correctly with Cal
2 Solution during
Startup.
11. Troubleshooting
Operator action
Refill AutoCheck carousel
when convenient.
Removal condition:
AutoCheck refilled.
- Ensure that sample is free
of air bubbles.
- Ensure that sample
volume matches the
selected sample mode.
- Check inlet tube. Replace
if necessary.
- Repeat the measurement.
- Ensure that sample is free
of air bubbles.
- Ensure that sample
volume matches the
selected sample mode.
- Check inlet tube. Replace
if necessary.
- Repeat measurement.
- Check and remedy other
fluid transport errors.
- Repeat the measurement.
- Check Cleaning solution
level. Replace container as
necessary.
- Perform Fluid transport
troubleshooting procedure.
- Check Cal 2 solution
level. Replace container as
necessary.
- Perform Fluid transport
troubleshooting procedure.
Continued on next page
11-41