RADIOMETER ABL800 FLEX Operator's Manual page 140

3. Installation and setup
Communications,
Automatic data This program allows you to select the conditions for requesting patient
request demographics automatically from the connected the RADIANCE system or from
LIS/HIS computer system when entering Patient ID, Accession Number or
Sampler ID.
FLEXQ:
Manual measurement:
To select the settings, do the following:
Step
NOTICE: If the requested patient data (e.g. Patient Last Name) was received after
exiting the Patient Identification screen, the patient report will be stored without
the requested data in the Patient Report log. The requested patient data will be
stored as a patient profile in the analyzer's database without, however, being
attached to any patient report.
3-74
Continued
The request will be made during scanning the sampler.
The request will be made when the corresponding data
is entered on the Patient Identification screen during
or after analysis.
Action
1. Select a connected device in the "From connection" box, using the
up/down arrows buttons.
2. Activate the relevant check button(s) to request patient demographics
from the connected RADIANCE system or LIS/HIS when:
– entering Patient ID
– entering Accession Number
– entering Sampler ID.
3. Press Close when completed.
ABL800 FLEX Operator's Manual
Continued on next page