RADIOMETER ABL800 FLEX Operator's Manual page 57

ABL800 FLEX Operator's Manual
Analyzer status,
Quality Control The Quality Control status provides the following information:
status
•
•
For the ABL8x7 FLEX analyzers, please note that Slot 11 will be automatically
installed when you scan the barcode for the Cleaning Met II Solution during
replacement.
Solution
Lot
Last Time
Next Time
Continued
status of the last measurement on each control solution type
messages referring to quality control measurements.
Element
Lists the quality control slot and its solution type along
with a status symbol.
Cleaning Met II Solution (for ABL8x7 FLEX analyzers
only) is used for quality control of high creatinine levels.
OK
?
?
The solution lot number for the slot.
Lists the time the last measurement was performed.
Lists the next scheduled time to perform the measurement
on the slot. See Quality Control Schedule, chapter 3.
Function
The last measurement was accepted.
One or more of the following occurred:
• error in the last calibration.
• analyzer error during last QC measurement.
• a parameter measurement is outside the defined
ranges or a Westgard Rule has been violated.
The next measurement is overdue, and the
previous measurement, if any, was accepted.
The last quality control measurement had errors
present, and the next measurement is overdue.
2. What Is what
Continued on next page
2-31