RADIOMETER ABL800 FLEX Operator's Manual page 177

ABL800 FLEX Operator's Manual
Patient result,
Patient result
Step
approval
(continued)
Acid-Base Chart Press Acid-Base Chart to view the acid-base chart for the selected patient result
(the button will not be available if pH and pCO
setup. The sample type should be either "Arterial" or "Capillary").
The chart illustrates the patient result according to the Siggard-Andersen
nomogram. The clinical conditions corresponding to each of the 8 zones listed to
the right of the screen.
Continued
Action
Reject Press Accept to reject the result and to send it to the
connected RADIANCE system or LIS/HIS.
Press the keyboard icon to write a note.
Press Cancel to return to the previous screen.
Rerun Press Accept to mark that the measurement should be
repeated, and to send it to the connected RADIANCE
system or LIS/HIS.
Press the keyboard icon to write a note.
Press Cancel to return to the previous screen.
Note Press the keyboard icon to type a note prior to the
approval or to edit a highlighted note.
To delete a highlighted note, press the keyboard icon and
delete the note.
Once the result has been approved/rejected/rerun, the ID data can only
be viewed, not changed (grayed-out input boxes). The Parameters,
Patient Lookup and Request buttons will not be available either.
In the Patient Report log you can filter patient reports according to the
approval status.
The Approval button changes to Send (if an external connection is
used) after the approval of the patient result has been made.
If result approval is used, data will not be transmitted to a LIS/HIS
connection before the approval has been made.
4. Sample measurements
were deselected in the Parameter
2
Continued on next page
4-23