RADIOMETER ABL800 FLEX Operator's Manual page 178

4. Sample measurements
Patient result,
Acid-Base Chart The point position is determined by the pH and pCO
(continued) result. If the pH and pCO
chart, the message "Measurement out of range
the Print button will disappear.
Available buttons:
Print = to print out the displayed acid-base chart and the corresponding patient
result, if available - see above.
Back = to return to the Patient Result screen.
NOTICE: The information provided by the acid-base chart should only be used as
a guideline for interpreting the patient's condition. The patient results must always
be examined carefully by a clinician before a proper diagnosis is made.
To recall the Patient Identification screen, press the ID button.
Recalling
patient ID
For detailed information, refer to the topic Patient Identification in this chapter.
Any changes made to an existing result will be registered in the Audit Trail.
Patient result
audit trail
The Messages button is substituted with the Log button to indicate that changes
were made.
To see the audit trail, do the following:
Step
4-24
Continued
2
Action
1. Press Log on the Patient Result screen to display the following
buttons: Audit Trail and Messages.
2. Press Audit Trail.
The audit trail contains information about the operator who made the
change, time of change and new/old values.
The changes made at the same time are indicated with "–" in Time
and User columns.
3. Use the up/down arrow buttons to scroll the list of changes.
Press Back to return to the Patient Result screen.
values are outside the defined limits of the acid-base
will appear on the chart in red and
"
ABL800 FLEX Operator's Manual
values from the patient
2