RADIOMETER ABL800 FLEX Operator's Manual page 210

7. Replacements
General information,
Recording
Step
replacements in
Hold mode
(continued)
(conti-
nued)
Entering Fluid The Fluid Replacements mode ensures that the proper restart sequence will follow
Replacements the exit from this mode.
mode
To enter the Fluid Replacements mode, do one of the following:
• Press Analyzer Status – Reagents – Replace.
• Remove a solution container
Recording To record replacements in the Fluid Replacements mode, do the following:
replacements in
the Fluid Step
Replacements
mode
7-4
Continued
Action
7.
(In case only the Crea electrodes were remembraned or replaced, the
Confirm Membrane Replacement screen will be used.)
Press Accept to start the restarting sequence or press Back to return to
the previous screen.
After the required action is completed, press Restart and then Accept.
Action
1. Press Analyzer Status – Reagents – Replace.
2. Remove the component to be replaced according to recommended
procedure.
ABL800 FLEX Operator's Manual
Continued on next page