RADIOMETER ABL800 FLEX Operator's Manual page 59

ABL800 FLEX Operator's Manual
Analyzer status,
Electrodes and The Electrodes and Other status shows the following:
Other status
•
•
Buttons:
Replace
Log Activity
Close
System messages See chapter 11: Troubleshooting.
AutoCheck AutoCheck Status is available only if the AutoCheck module has been installed. It
shows the following:
status
•
•
Continued
replacement schedule for items replaced in the Hold mode
messages referring to replacements or user activities.
Highlight the item and press this button to enter the screen for
replacements of electrodes/membranes – see Replacing
membrane or electrode in chapter 7.
Activate "User Activities" part of the screen to make this
button visible. When the button is visible, press it to enter the
User Activity program to edit the user activities list – see
chapter 3 in this manual.
Press to exit to the Ready screen.
status of the carousel and the measurements scheduled in the QC Schedule
program (see section Quality control setup in chapter 3).
Messages referring to AutoCheck.
2. What Is what
Continued on next page
2-33