RADIOMETER ABL800 FLEX Operator's Manual page 141

ABL800 FLEX Operator's Manual
Communications,
Automatic Data This program allows you to set up automatic sending of data to a connected
Transmission LIS/HIS computer system or to the RADIANCE system.
Setup
To select the settings, do the following:
Step
NOTICE: If the requested patient data (e.g. Patient Last Name) was received after
exiting the Patient Identification screen, the patient report will be transmitted
without the requested data. To prevent this, select one of the patient data items
transferred from LIS/HIS as mandatory.
Patient Lookup This program allows you to select the data source in order to obtain the patient
Setup information on the Patient Identification screen.
To select the settings, do the following:
Step
Continued
Action
1. Highlight a desired connection device on the screen, using the
up/down arrows (note that the "FLEXQ Sample Status" is not
available if connection to the RADIANCE system has been selected).
2. Activate the relevant check button(s) to select the data to be sent to the
highlighted connection.
Action
1. Select a data source from the established connections (local database,
RADIANCE or LIS/HIS).
3. Installation and setup
Continued on next page
3-75