Adjusting The Sensor Output (Electrical System (Puncher Unit; Option)) - Toshiba e-studio200l Service Handbook

3.13.2 Adjusting the sensor output (Electrical system (Puncher unit;
option))
Perform the following when the punch controller PCB, horizontal registration sensor (photosensor PCB/
LED PCB), or waste full sensor (waste full photosensor PCB/waste full LED PCB) has been replaced.
<Procedure>
(1) Shift bits 1 through 4 on the punch controller PCB as follows:
(2) Press SW1002 or SW1003 on the punch controller PCB. A press will automatically adjust the
sensor output.
• The adjustment is over when all LEDs on the punch controller PCB are ON: LED 1001,
LED1002, LED1003.
(3) Shift all bits of DIPSW1001 to OFF.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ON
1 2 3 4
Fig. 3-130
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
3 - 97
3
ADJUSTMENT