Clear The Als-Disabled Condition - Cisco NCS 2000 series Troubleshooting Manual

Clear the ALS-DISABLED Condition

Clear the ALS-DISABLED Condition
SUMMARY STEPS
1. In node view (single-shelf mode) or shelf view (multishelf mode), double-click the OPT-BST, or OPT-PRE,
OPT-AMP-C, or OMP-AMP-17-C card to display the card view.
2. Click the Maintenance > ALS tabs.
3. In the ALS Mode column, change the entry from Disabled to your required state.
DETAILED STEPS
Step 1 In node view (single-shelf mode) or shelf view (multishelf mode), double-click the OPT-BST, or OPT-PRE, OPT-AMP-C,
or OMP-AMP-17-C card to display the card view.
Step 2
Click the Maintenance > ALS tabs.
Step 3 In the ALS Mode column, change the entry from Disabled to your required state.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AMPLI-INIT
Default Severity:Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: AOTS
The Amplifier Initialized condition occurs when an amplifier card (OPT-BST or OPT-PRE) is not able to
calculate gain. This condition typically accompanies the
Clear the AMPLI-INIT Condition
SUMMARY STEPS
1. Complete the
2. Recreate this circuit using the procedures in the Configuration guide.
DETAILED STEPS
Step 1
Complete the Delete a Circuit, on page 454
Step 2 Recreate this circuit using the procedures in the Configuration guide.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
118
Delete a Circuit, on page 454
procedure on the most recently created circuit.
http://www.cisco.com/c/en/us/support/index.html
APC-DISABLED , on page 119
procedure on the most recently created circuit.
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting
alarm.