Erfi-P-Srvr - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
4. If the alarm does not clear, replace the ribbon cable from the AIP to the system board with a known-good
ribbon cable.
DETAILED STEPS
Step 1 If the alarm is reported against the fan, verify that the fan-tray assembly is present.
Step 2
If the fan-tray assembly is present, complete the
Step 3 If no fan-tray assembly is present, obtain a fan-tray assembly and refer to the Install the Fan-Tray Assembly procedure
in the Hardware Installation Guide.
Step 4 If the alarm does not clear, replace the ribbon cable from the AIP to the system board with a known-good ribbon cable.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html
en/us/support/web/tsd-cisco-worldwide-contacts.html
your country.

ERFI-P-SRVR

Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: STSMON, STSTRM
The Three-Bit ERFI Path Server condition is triggered on DS-1, DS-3, or VT circuits when the
page 117
Clear the ERFI-P-SRVR Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the LOP-P Alarm, on page 270
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
ESMC-FAIL
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: GE, TRUNK
Replace the Fan-Tray Assembly, on page 460
or the LOP-P , on page 270
Clear the LOP-P Alarm, on page 270
for more information or log into
to obtain a directory of toll-free Technical Support numbers for
is raised on the transmission signal.
procedure. This should clear the ERFI condition.
procedure. This should clear the ERFI condition.
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
ERFI-P-SRVR
procedure.
http://www.cisco.com/c/
AIS-P , on
185