Cfm-Mep-Down - Cisco NCS 2000 series Troubleshooting Manual

CFM-MEP-DOWN

CFM-MEP-DOWN
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Objects: ETH
The Connectivity Fault Management Maintenance End-Point Down (CFM-MEP-DOWN) alarm occurs in
GE_XP, 10GE_XP, GE_XPE or 10GE_XPE cards when two maintenance end points cannot communicate
with each other.
Clear the CFM-MEP-DOWN Condition
SUMMARY STEPS
1. Make sure that there are no fiber cuts or other CFM alarms present.
2. In card view, click the Provisioning > CFM > CCDB > Counters tabs.
3. Ensure that the counter values in the CCM Received field is equivalent to the counter values in the CCM
Transmitted field and that the counter is incrementing appropriately.
DETAILED STEPS
Step 1
Make sure that there are no fiber cuts or other CFM alarms present.
Step 2 In card view, click the Provisioning > CFM > CCDB > Counters tabs.
Step 3
Ensure that the counter values in the CCM Received field is equivalent to the counter values in the CCM Transmitted
field and that the counter is incrementing appropriately.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
CFM-XCON-SERVICE
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Objects: ETH
The Connectivity Fault Management Cross-Connect Service (CFM-XCON-SERVICE) occurs in GE_XP,
10GE_XP, GE_XPE and 10GE_XPE cards when the domain are configured incorrectly, and a packet meant
for a one domain goes to the other.
Clear the CFM-XCON-SERVICE Condition
SUMMARY STEPS
1. In card view, click the Provisioning > CFM > Configuration > MEP tabs.
2. Do the following to ensure that the maintenance association and the domain names are the same.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
156
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting