Cisco NCS 2000 series Troubleshooting Manual page 583

Error Messages
Error/Warning
ID
EID-6071
EID-6072
WID-6073
EID-6074
EID-6075
EID-6076
EID-6077
EID-6078
EID-6079
WID-6080
EID-6081
EID-6082
EID-6083
EID-6084
WID-6085
EID-6086
EID-6087
Error/Warning Message
The TARP data cache cannot be flushed.
The TARP data cache entry cannot be added: {0}
A TARP request has been initiated. Try refreshing the
TARP data cache later.
End system mode only supports one subnet.
An error occurred while trying to remove a MAT entry.
The entry does not exist.
An error occurred while trying to {0} a TARP manual
adjacency entry: {1}
The area address must be between 1 and 13 bytes long,
inclusive.
A TDC entry with this TID {0} does not exist in the
table.
A TDC entry with this TID {0} could not be removed.
Please verify that TARP is enabled.
Router {0} does not have an area address in common
with Router 1. Switching from IS L1/L2 to IS L1 in
this case will partition your network.
The limit of 10 RADIUS server entries has been
reached.
{0} cannot be empty.
The entry you selected for editing has been altered by
another user. The changes cannot be committed.
The RADIUS server entry already exists.
Disabling shell access will prevent Cisco TAC from
connecting to the vxWorks shell to assist users.
The card cannot be changed because card resources are
in use.
The card cannot be changed because the card type is
invalid or incompatible.
Description
You cannot flush the cache in the
Tunnel identifier Address Resolution
Protocol (TARP) state.
You cannot add the specified cache
entry.
Refer to the warning message text.
Refer to the error message text.
CTC is removing the MAT entry.
CTC cannot add the specified
adjacency entry for reasons unknown.
The area address should not be more
than 13 characters.
The specified Tunnel Identifier does
not exist.
You must enable TARP to remove the
TDC entry.
Refer to the warning message text.
CTC does not allow more than 10
RADIUS servers.
The Shared Secrets field should not
be empty.
Refer to the error message text.
Specify another RADIUS server entry.
Refer to the warning message text.
The card you are trying to remove is
being used. Cannot change the card.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
537