Cisco NCS 2000 series Troubleshooting Manual page 588

Error Messages Reference
Error/Warning
ID
EID-6157
EID-6179
EID-6196
EID-6197
WID-6204
EID-6205
EID-6206
EID-6207
EID-6208
EID-6209
EID-6210
EID-6211
EID-6212
EID-6213
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
542
Error/Warning Message
The watermark values are either out of range or
inconsistent.
The 1+1 protection group is not optimized.
The equipment has failed or is missing.
Attributes cannot be changed when the port
administrative state is {0}.
This action will cause the node to reboot. When
provisioning in single-shelf mode, Shelf {0} of the node
that you connect to must be properly preprovisioned or
you will lose traffic. Use the LCD to return to
single-shelf mode. CTC cannot be used for this.
Changing from subtended shelf mode to single-shelf
mode could be traffic-affecting.
The interlink port is not provisioned.
The ADM peer group has already been created on the
peer card.
This card is not in the ADM peer group.
The payload is not OTU2.
The side is already defined by the node.
No side was selected.
The side was not deleted.
One of the ports is connected to a patchcord or virtual
link.
It is not possible to associate the side to the two ports.
Error Messages
Description
Enter valid watermark values.
Refer to the error message text.
Operation is requested on a failed or
missing equipment.
You cannot change the attributes when
the port is in the specified
administrative state.
Refer to the warning message text.
The user creates an ADM peer group
without interlink ports.
The user creates an ADM peer group
involving an ADM card inserted in a
peer group.
The selected ADM card is not
involved in an ADM peer group.
Refer to the error message text.
During the creation of a side on node,
a side is already defined.
The user requests an operation on a
side, but no side is selected.
CTC could not delete the selected side
successfully.
An operation on a port was not
performed because the port is
connected to a patchcord or a virtual
link.
During the creation of a side it is not
possible to associate the selected ports
to the new side.