Cisco NCS 2000 series Troubleshooting Manual page 541

Error Messages
Error/Warning
ID
EID-2211
EID-2212
WID-2213
EID-2214
EID-2215
EID-2216
EID-2217
EID-2218
EID-2219
EID-2220
EID-2221
EID-2222
EID-2223
EID-2224
EID-2225
EID-2226
Error/Warning Message
No node was selected for upgrade.
A protected line is not provisionable.
The current type or state of some drops does not allow
the new circuit state of {0} to be applied to them
indirectly.
The node is disconnected. Please wait until the node
reconnects.
An error occurred while leaving the {0} page.
An error occurred while entering the {0} page.
Some conditions could not be retrieved from the
network view
The bandwidth must be between {0} and {1} percent.
The protection operation failed. An XC loopback was
applied on the cross-connection.
The tunnel status is PARTIAL. CTC is not able to
change it. Please try again later.
A valid route cannot be found for the unprotected to
{0} upgrade request.
One or more of the following nodes are currently part
of a four-fiber {0}. Only a single four-fiber {0} is
supported per node. {1}
Only one circuit can be upgraded at a time.
This link may not be included because it terminates on
the source.
A valid signal could not be detected while trying to
complete the roll. {0}
The circuit roll failed. {0}
Description
You must select a node for the
upgrade.
The protected line cannot be
provisioned. Choose another line.
The circuit state, specified by {0}
cannot be applied to the selected
drops.
Refer to the error message text.
There was an error while leaving the
specified page.
There was an error while entering the
specified page.
Refer to the error message text.
The bandwidth must be within the
specified parameters.
As the protection operation failed, a
cross-connect (XC) loopback will be
applied on cross-connection.
Refer to the error message text.
Refer to the error message text.
The nodes, specified by {1}, are
already part of a 4-fiber
BLSR/MS-SPRing type (specified by
{0}).
Refer to the error message text.
Refer to the error message text.
Roll can be completed only when a
valid signal is detected. If not, the roll
completion may result in an error.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
495