Cisco NCS 2000 series Troubleshooting Manual page 562

Error Messages Reference
Error/Warning
ID
EID-3381
EID-3382
EID-3383
WID-3384
EID-3385
EID-3386
EID-3387
EID-3388
EID-3389
EID-3390
EID-3391
WID-3392
WID-3393
EID-3394
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
516
Error/Warning Message
The maximum frame size must be between {0} and {1}
and may be increased in increments of {2}.
The number of credits must be between {0} and {1}.
The GFP buffers available must be between {0} and
{1} and may be increased in increments of {2}.
You are about to force the use of Secure Mode for this
chassis. You will not be able to undo this operation. Is
it OK to continue?
{0}. Delete the circuits and try again.
The transponder mode could not be provisioned: {0}
You must change port(s) {0} to an out-of-service state
before changing card parameters. Click Reset to revert
the changes.
The card mode cannot be changed because the card has
circuits.
An error occurred while changing the card mode.
The port is in use.
The port rate cannot be changed because the port has
been deleted.
The timing reference(s) could not be assigned because
with external timing, only a single protected, or two
unprotected timing references per BITS Out can be
selected. Please use the "Reset" button and verify the
settings.
The timing reference(s) could not be assigned because
with line or mixed timing, only a single unprotected
timing reference per BITS Out can be selected. Please
use the "Reset" button and verify the settings.
An error occurred while refreshing the power
monitoring values.
Error Messages
Description
The frame size must be in the specified
range. This can increment by the
specified value.
The number of credits must be
between the specified values.
The GFP buffers must be in the
specified range. This can increment
by the specified value.
Refer to the warning message text.
Refer to the error message text.
The specified transponder mode
cannot be provisioned.
All the card ports should be changed
to out-of-service before changing the
parameters.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
You cannot change the port rate of a
card that has been deleted.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.